|
|
bridge cutting machine maintain and maintain
Time：2018-01-20 Hits：3714
1. lubricating oil and hydraulic oil tank
Rack at both ends of the rack bearing oil pool, to maintain the seal and the oil level. V-shaped bed rail bed rails and walking racks should also maintain the level of oil, oil deterioration or water should be timely oil change. Lifting and round guide lubrication system manual pump, 30 # mechanical oil should be added and at least once per shift. Always observe the bed before and after moving reducer and take the knife reducer and the main window oil level, at least once a year oil change.
On the flip table flip axis, flip cylinder bearings, piston rod support shaft, the table rotary gear transmission lubrication points, each class must add grease or fat once. At the end of the work stoppage, the workbench must be lifted in order to make the turnover mechanism move once, to avoid rusting, and to help the workbench water to dry and prevent the decay of the wood on it.
2. button boxes and appliances
Control table flip, rotating button box, inevitably splashing water on the cutting board, over time, will cause the button contacts rust, to be checked regularly, remove the rust point. The device used in the PLC control system 18 micro-relay, the contact capacity is small, frequent movements, resulting in poor relay contacts often occur, so when it is required to check or replace. Replace the relay as long as the open ground gently touch the contacts, the general can be restored to use. The solenoid valve connector, there will be loose loose contact failure, the same should be given to reproduce.
Hesheng machinery was established in 1980,produce Automatical Bridge Saw.High Efficiency Multidisc Block Cutter.Gantry Block Cutter. Manual Edge Cutting Machine. Special Shape Processing Machine for Countertop.Column...Collection of Polishing Machine and other cutstomize equipment for processing slab and block material.
|
